Barley Crusher with large hopper holds approximately 15 pounds of grain
5" rollers have a 12 TPI knurl that pulls grain through while leaving the hull intact to form an excellent filter bed for sparging
Rollers are adjustable at both ends to keep the gap spacing parallel giving a uniform crush along the entire length of the rollers.
Sturdy construction
3 Reviews Hide Reviews Show Reviews
-
Barley Crusher Review
This malt mill gives a great crush. It comes set with a roller gap of about 1mm, which does a great job. I had to tape some duty aluminum foil on the outer sides of the hopper, though, to stop some grain from going over the rollers and being wasted. It is a little awkward to turn as I hold the mounting board with one hand and turn the crank with the other. Wheat malt was much harder to crush. A drill or some other means of running the mill would be preferable. I haven't needed to adjust the roller gap, yet as the crush is great!
-
Grain Mill/crusher
Hooked mine up to a drill. Worked great.
-
Excellent Service
Thank you for allowing me to pick this outside during this time in quarantine, It was greatly appreciated!